X

Track changes made to this page

If you find this page useful and would like to be notified of changes made to this page, start by inputting your email below.



Privacy policy
Close this window

powered by ChangeDetection

34-167-29658

Well Details

Well ID: 34-167-29658
Loading map...
County:
Municipality:
Operator Name:
Well Pad ID:
Farm/Lease Name:
First Permit Date:
Last Permit Date:
Spud Date: 2008-05-13
Unconventional:
Horizontal:
Producing: No
Violations: 0
Latitude: 39.3918899404
Longitude: -81.3171291256

Production Data

PERIOD GAS QUANTITY GAS PRODUCTION DAYS CONDENSATE QUANTITY CONDENSATE PRODUCTION DAYS OIL QUANTITY OIL PRODUCTION DAYS

Waste Data

PERIOD TYPE QUANTITY UNITS DISPOSAL METHOD WASTE FACILITY PERMIT ID WASTE FACILITY NAME FACILITY CITY FACILITY STATE

Inspection Data

INSPECTION ID DATE DESCRIPTION COMMENT VIOLATION ID VIOLATION CODE VIOLATION_COMMENT
-1009930694 2010-08-23 Inspection this day found well in production, pump running. Pressure on tubing is 1820#, 0# on annulus. Good ID's, all looks good. Well is being charted.
-1025084211 2009-08-31 Inspection this day found pumps running, well taking water. All looks good.
-1031027108 2009-07-23 Inspection this day found location has been reclaimed, completely finished and grass growing, no debris. Injection well.
-1332328564 2008-11-19 Inspection this day found no one at well. Pump running, reclamation is being worked on and needs to be finished, not done yet, due to the weather, I believe. Pressure chart at well, good ID's, water coming thru pipeline from 2+ miles away - other well at this facility on the river where tanks, pump are located.
-1430863003 2012-11-20 Inspection revealed that injection pump was in operation during my inspection and well site was in satisfactory condition this inspection.
-1477582439 2012-10-30 I met today with Tim Leftwich & Doug Aden, OGS and Glenda Besana-Ostman, DNR- UIC, to show them possible good sites for further seismic monitors. We discussed the requirements needed for a good site and I showed them one outside Newport, located between 2 soon-to-be approved new disposal wells and they installed one of the units this day. Also showed them several other sites (one of which is near this well) to choose from for monitors they will bring in following weeks.
-1480015238 2013-01-16 Inspection on this day revealed that injection pumps were in operation and found pump house clean and neat and facility appears to be in satisfactory condition this inspection.
-1530501340 2010-05-24 Inspection this day found pump running, pressure on well. Good ID's, no violations.
-1565442962 2008-07-15 Rig crew on location, getting ready to leave. Waiting on orders, was told a parafin block in 4.5" casing, rental tubing on location and will go in with small bit and drill out blockage - well flowing this day so are not going to work on it. Water getting around this blockage so not solid, my idea to go in with solvent, let set and see if that doesn't take care of it. Hopefully, can run packer 7/21/2008.
-182746821 2008-08-21
-1893203788 2008-07-24 Inspection this day found service rig circulating on hole thru the bit and 2 7/8" casing. Got back down to bottom, will come out and start running coated pipe with packer on Monday morning. Well perf'd at 6978-7134' - blockage had been at 6405' - they believed it to be paraffin. Pressure test late Monday or Tues. morning.
-2022594955 2012-08-23 Inspection revealed that injection pump was in operation during my inspection and it was discussed that small leak on injection pump would be fixed by the end of the day.
-402575674 2008-07-28 Ran A-3 Lock Set packer in well on 2 3/8" tubing to 6906' - Baker on location to supervise running of packer. Well set and pressure test next morning.
-411408206 2012-06-13 Inspection revealed that injection pump was in operation during my inspection.

Note: Curbing needs installed at pump house entrances to prevent any brine from leaving building it appears that when care taker washes out building that there is salt residue out on stone in front of building.

-443796612 2009-08-31 Inspection this day found pumps running - all looks good. Reclamation has been done, grass growing.
-508920119 2008-06-02 Inspection this day found drill pit has been squeezed down to about half. OOG representative out on locationn and reports A & R Energy has filed an injuction preventing further work until OOG gets a valid lease Crew out there today putting in temporary electric, water truck emptying frac tanks used for drilling. Water is being hauled.
-626328716 2012-02-10 My inspection this day due to quarterly requirements. Pressure readings are taken off the company computer that is constantly monitoring the wells. Tubing pressure is 1940#, annulus is 430#. The pump is running this day. Identification as required. The operator reports no problems.
-639076516 2014-06-16 Inspection revealed that injection pump was in operation during my inspection.
-660465936 2009-11-20 Inspection this day found no violations, small fence built around well, grass growing nicely. Pressures were 1700# tubing, 0# on annulus.
-667772071 2011-05-24 Inspection this day found pumps running, well taking water, flow being charted. Pump and location clean, good ID's. Tubing 1900#, annulus is 350#.
-674622757 2009-02-12 Quarterly inspection this day found no violations, pump running, good ID's, location still needs reclaimed but weather has not permitted - hopes to have done in next couple months, Bruce says. Also says water has been done some, last couple months.
1053242287 2010-11-22 Inspection this day found well hooked up to computer - no longer have a way to put my gauge on. Chart shows annulus and tubing pressure, also is being monitored thru computer at pump house. All looks good - pumphouse is spotless! Talked to T. Tomastic and he said fine if I use their computer readings for pressure.
1222789100 2008-10-06 On Friday, 9/26, service rig set up with Baker man and unhooked packer. Ran dye down tubing to try and determine where leaking - dye circulated with the conclusion that tubing had the leak, not the packer. Tubing was re-connected to packer and both were pulled, finishing up on 9/29/08. As tubing was pulled, found all the joints to be lose enough to leak, surprising as power tongs were used to tighten pipe. Also, several plastic collars used with the coated pipe were found in the tubing, some crushed, and coating on the pipe appears to be damaged. Also marks on packer indicating some rough treatment. New coated pipe was ordered. 10/2 Packer was run back in hole along with new coated pipe and collars. Tally on tubing that had come out of hole was off about 25' - maybe measured wrong or missed a joint. Baker man present to run packer back in and observe. 10/4 Pulled tubing and packer, 10/5- Ran tubing, packer back in, this time tightening joints over recommended limits, 10/6- Set packer, closed valve, tested tubing and annulus, both holding, circulated inhibitor, tested tubing again and started injecting.
1312378559 2011-08-02
1322067122 2011-11-21 Inspection this day found no change in well or facility. Facility is clean, the integrity of pipe good, proper identification is posted, operational flowmeter and pressure gauge at well. Pressure readings were taken off computer at office.
1386965570 2013-12-13 Inspection revealed that injection pump was in operation and it was noted that injection pump has been slowed down at request from Central Office.
1388100657 2013-12-23 On site with company personnel to test annulus of tubing they pressured up too 300# and we monitored pressure with a small leak detected within tubing head, bleed pressure off and tighten head and retested and it still leaked a little so decision was made to order new packing for tubing head and once packing comes in we will retest well.
1447494134 2010-02-24 Inspection this day found no violations, pumps running and this well taking water at 1675# on tubing, 0 on annulus.
1453617165 2008-07-31 Inspection this day found crew doing flow testing. Well injecting at 56 bbl/hour at 1200# - water being trucked into tanks on location - short piece of line connecting well to tanks. Pipeline not completed yet.
1475059360 2008-07-16 Called out today as they are ready to pump saltwater into the temporary pit at the oil gathering facility. Heavy plastic liner has been hot-welded together to prevent leaks - water will start going in 7/17/2009 - they will have 120 days.
1621469158 2008-09-08 Met with Bruce Phipps of OOG regarding tubing leak. Well showed 600# on tubing, 600# on casing, and had been shut down since Friday (9/5/08). Talked to Tom Tomastik to get his opinion, then shut well down until tubing leak fixed. Service rig could have been on location today but Baker who operates packer could not get there for 2 weeks, Tom Roberts reports.
1625873439 2012-12-12 Inspection revealed that injection pump was in operation today and pump house was clean and tidy this inspection.

Note: Lease road to wellhead is in need of grade work preformed.

1701304756 2008-08-18 First inspection since pipeline has been completed and are injecting water from their facility along the river, not tanks on location which they were temporarily hauling into. Tubing pressure 1400#, annulus pressure 800#. Still need ID's. Location has not been reclaimed. Operator reports tubing or packer is leaking - they think tubing and have rig scheduled for 8/25/08 to pull and find problem.
1776054022 2013-04-30 Inspection revealed that injection pump was in operation during my inspection.

Note: 2" nipple on injection line is showing signs of needed replacement and also high pressure hose going to meter box is showing signs of fatigue.

199717251 2013-12-02 Inspection revealed that injection pump was in operation during my inspection.

Note: Storage tanks are located at the Bell's Run Facility.

20272458 2014-04-10 Inspection revealed that injection pump was in operation during my inspection and it was noted that pump house has been recently cleaned and organized.
226236489 2012-12-27 Inspection revealed that injection pump was in operation during my inspection.

Note: Pump house was clean and neat and floors were recently cleaned.

382705366 2008-07-29 Inspection this day for testing of pipe integrity. Set A-3 Lock Set packer, unset packer to load hole. Circulation broke at 29 bbl. Circulated 62 bbl of corrosion inhibitor with 8 bbl going into pit, @ 2bbl left in tubing to cover packer. 30 bbl fresh water to load tubing. Reset packer. Pressured up to 1905# with pump truck. After 15 min., my gauge read 1850#. Passed test. Will start volume and rate testing tomorrow.
588227173 2014-08-14 Inspection revealed that injection pump was in operation today and it was noted that two 1/4" valves on wellhead have been changed since my last inspection.
663610721 2008-07-10 Inspection found service rig on location - were supposed to run packer on tubing and pressure test but having trouble with the well - can't get down the casing with tools, black, sticky substance coming out of well and took sample to be analyzed. Analysis back today says it is parafin - where coming from? Choices are dirty frac tanks or from formation, I would say. Waiting on plan to remove blockage and run tubing.
681028416 2009-05-27 Inspection this day found pump running, from location along the river. Reclamation stills needs finished up - ground has been smoothed but small pit still needs filled in, grass sown.
757152930 2011-02-23 Inspection found no violations, pump at station running, pressures 1880#, 40# on annulus. Pressures are being tracted and monitored by computer, gate for house not closing easily.
863571910 2013-08-21 Inspection revealed that injection pump was in operation during my inspection.