X

Track changes made to this page

If you find this page useful and would like to be notified of changes made to this page, start by inputting your email below.



Privacy policy
Close this window

powered by ChangeDetection

34-175-20341

Well Details

Well ID: 34-175-20341
Loading map...
County: Wyandot
Municipality:
Operator Name: MAR OIL COMPANY
Well Pad ID:
Farm/Lease Name:
First Permit Date:
Last Permit Date:
Spud Date: 2002-12-12
Unconventional: No
Configuration: Vertical
Well Status: Active Injection
Violations: 0
Latitude: 40.68762409
Longitude: -83.408757

Inspection Data

INSPECTION ID DATE DESCRIPTION COMMENT VIOLATION ID VIOLATION CODE VIOLATION COMMENT
-1012682587 2005-07-27 Inspect Well.
1045845792 2003-02-20 Appeared that bridge plug had been drilled out since squeez job of perfs was not able to be preformed last week. Spoke with Don of Mar Oil via phone 2/21/03 and he confirmed that is had been drilled out. Plug job to resume next week.
1054232423 2003-05-27 Inspected site at request of Tom Tomastik for review of salt water injection application. Tank storage facility is on site but not yet constructed per application requirements with sand base and 30 mil plastic liner. Spoke with Mar Oil official ( Don) and he advised that the storage area will be divided and reconstructed. The proposed injection well head is located approximately thirty feet away from a water well with artesian flow coming out of the plastic casing. There is also a nearby creek with the site appearing to be in a floodplain area. Mar Oil was also advised to fill in the drilling pits and use tanks during any other drilling.
1059743421 2003-07-31 CONDUCTED INITIAL MIT, TEST PASSED
1088537846 2004-06-29 Chk well and storage with Jeff Fry. Ok. Injection pump not running at this time.
-1102523641 2008-12-10 Inspect well. Id posted.
1105890904 2015-01-21 Inspect well for integrity and pressure.
1106598707 2015-04-14 Inspect well for integrity and pressure.
-1114330548 2004-12-28 Inspect well.
1134249199 2009-09-16 Inspect well and location.
1171554368 2010-10-04 Inspect well.
-121730028 2004-06-22 Inspect Well.
-1236963368 2005-02-22 Inspect Well.
1239123188 2009-04-06 inspect well. No activity. Concrete dike area about half full with water.
1240075174 2009-11-23 Inspect well location.
1290009634 2010-11-16 Inspect well.
1310136869 2011-06-24 Inspect well. Site ok.
-1345852002 2006-01-26 Inspect Well.
1361808668 2013-02-25 Inspected the Born #3 (#341) (SWIW #3) as part of a standard injection well status check. Vault and storage dike areas are clean, identification and emergency contact information is clearly posted at the storage. Identification needs posted at the well, met with Mar Oil pumper Brett Buxton on location and notified him. Annulus pressure 40 psi on state issued gauge. Status: ok.
-1373201655 2003-01-30 Spoke with landowner and drill crew member. Tanks and lines were going to be hooked up for production.
1378308455 2013-09-04 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Check well, storage, vault, pressures and identification. No change in status from previous inspection. Status: ok.
1389286488 2014-01-09 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Check well, pressures, storage, vault and identification.
1392145035 2014-02-11 Location Information. ENTRANCE: Lat. 40.68737 Long. -83.41152 / WELL HEAD: Lat. 40.68754 Long. -83.40862 / CENTER-OF-STORAGE: Lat. 40.68750 Long. -83.41109.
1401295709 2014-05-28 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Inspect well, pressures, storage, vault and identification. Status: ok.
1410871321 2014-09-15 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Inspect well, storage and identification. Status: no change in status from previous inspection.
1416644389 2006-07-24 Inspect Well. Site OK.
1478174666 2004-02-26 Inspect well and tanks. Two 300 bbl tanks.
-1500498816 2007-01-23 Inspect well.
-1531128974 2007-08-06 Inspect well. Site ok.
-1560546412 2013-04-03 Inspect well and storage tanks. Measure concrete dike area. Two 300 bbl steel tanks that are isolated from each other.
-1574479836 2009-06-02 Inspect well. Well is in production. Contacted operator by phone. Operator reported Mat Pettigrew was operating wells, and Kenny Vandyke was the local pumper. Reported to operator that well needed to be pressured up. Reported to operator the tank was overflowing brine from a flexible discharge hose laid along the stairs and into the concrete dike containment.
-1598155023 2006-01-30 Operator was requested to pressure up annulus and conduct a mini test. Pressure to 260 psi and held with zero drop for 15 minutes.
-159868819 2008-01-28 inspect well.
-161676697 2014-09-12 Inspect well and tanks. No identification at well head. Contacted operator by phone to update identification.
-170442515 2008-03-19 Inspect facility. Due to heavy rain area adjacent and around well was flooded with one to two feet of water.
-1709099837 2015-05-06 Inspect the Born (SWIW #3) with UIC Inspector Tom Benko. Status: contacted operator for additional clean-up of oil from a tank over inside the concrete secondary containment.
-1772794048 2006-12-12 Inspect location and test annulus. Site ok.
1837747126 2015-05-04 Inspect injection well with Inspector Jeff Fry. Status: ok.
1860574408 2005-09-28 Inspect Well.
1928605286 2007-03-28 Inspect location.
-2008405943 2012-10-09 Collected a brine sample from storage tank for the Brine Sampling chemical analysis project. Sample ID TSB011. The water is production water from the Hackworth 2HZ.
2016767879 2012-02-24 Inspect Well.
2023265567 2010-01-28 Inspect well. Site ok.
-2044072347 2011-05-04 Run 48 joints of New pipe for UIC well. Use a 5.5 x 2 7/8 AD-1 Baker Torsion Packer ID and 2 tail pipe sections. Run in 10 joints set packer and pressure test for 20 minutes, test ok. Release packer run remainder pipe in hole. Attempt to displace fluids
2054395929 2007-05-21 inspect well. Two 300 BBL tanks.
-2075130201 2005-11-16 Inspect Well.
2081159781 2014-03-13 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Inspect well, pressures, storage, vault and identification. Status: no change in status from previous inspection.
-2100447591 2004-10-27 Inspect Well. ID posted.
2117200049 2010-07-26 Inspect well and tanks. Site ok.
221324275 2008-06-03 inspect well and site. Site ok.
-24579157 2013-12-10 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Check well, pressures, storage, vault and identification. Status: no change in status from previous inspection.
-275385771 2014-10-07 Inspect well for integrity and pressure.
-278705941 2009-07-21 Inspect well. Annulus has been pressured up to 100 psi.
-296800187 2012-12-05 Inspect well for integrity and pressure.
306181971 2011-10-11 Inspect well.
338605924 2011-01-27 Inspect well. Check pressures. Site ok.
390640409 2014-07-02 Inspect well for integrity and pressure.
-40100185 2007-09-24 inspect well. Site ok.
-425510692 2006-01-17 Well in production / injection. Pits closed. Preliminary restoration complete.
-428312565 2015-05-21 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Inspect well, pressures, storage and identification.
442727774 2010-09-13 Inspect well. Site ok. No meter.
-461806138 2013-11-15 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Check well, storage, pressures and identification. Unable to check tubing pressures due to the lack of 1/4 inch fitting. No permit displayed at well head and the vault needs emptied and cleaned out. Status: UIC Inspector Tom Benko contacted operator.
502231358 2007-11-14 Inspect facility. Site ok.
51436987 2005-04-28 Inspect Well.
525508263 2012-09-05 Inspect Well. Well head needs a 0.25 inch tap on injection line. Identification needs to be posted at well head. Truck transfer pad needs to be puped out and cleaned out. Contacted operator by phone.
-556258067 2015-06-16 Attempted to inspect well. The Little Tymochtee Creek has breached it banks and the access to the well is flooded.
-568161398 2015-06-04 Inspect well and storage area. The operator has cleaned up and power washed the interior of the containment after the storage tanks were over filled. No identification is posted at the well head. A 0.25 inch test port is required on the injection tubing at the well head.
-574394589 2010-03-30 Inspect well.
589746538 2009-01-27 Inspect facility. Facility is idle.
607707602 2004-04-21 Inspect Well.
-609157273 2011-04-08 Operator pressured up to 190 psi then pressure dropped back to zero and went onto a vacuum. Tubing has failed.
704213085 2006-03-29 Inspect Well.
-724655427 2006-09-21 Inspect well.
-745224035 2012-04-30 Inspect Well. No ID at well head.
-779634391 2006-05-30 Inspect Well. Site OK.
-801471123 2004-08-25 Inspect Well.
-830132071 2008-07-28 Inspect location.
-881451704 2010-05-25 Inspect well and tanks.
-894106156 2003-10-21 Inspect Well. Well is on vacuum. Site looks good. Concrete Dike for injection storage tank, Buried fiberglass conduit, production line has been installed inside fiberglass conduit. Identification is posted at well.
95165236 2013-05-20 Inspect injection well, storage, vault and identification. Status: compliant.
-972230347 2003-12-22 Inspect injection well.
-995163024 2014-02-11 Inspected the Born #1 (SWIW #3) as part of a standard injection well status check. Inspect well, pressures, storage and identification. Status: ok, site is snow covered.
-999054653 2008-09-09 Inspect well and location with Jeff Fry. ID posted. Well on vacuum, no meter.

For data sources see[1]

References

  1. ↑ "Ohio Department of Natural Resources RBDMS". [1]. 2015-06-19. Retrieved 2015-06-20. 
Retrieved from "https://wellwiki-prod.cloud.arc.gwu.edu/index.php?title=34-175-20341&oldid=3899893"