X

Track changes made to this page

If you find this page useful and would like to be notified of changes made to this page, start by inputting your email below.



Privacy policy
Close this window

powered by ChangeDetection

37-117-21919

Well Details

Well ID: 37-117-21919
Loading map...
Country: United States
State: Pennsylvania
County: Tioga
Municipality: Shippen Township
Operator Name: SWEPI LP
Well Pad ID:
Farm/Lease Name: HOUCK 433 10H
License Status:
Spud Date:
Permit Date: 2017-10-04
Well Type: GAS
Unconventional Well: Y
Configuration: Horizontal Well
Conservation: No
Latitude: 41.725597
Longitude: -77.405903

For data sources see[1][2][3]

Well History

Date Event
2017-10-04 New Permit Application

For data sources see[4]



Inspection Data

Inspections Performed

Inspection ID Inspection Category Inspection Date Inspection Type Inspection Result Inspection Comments
2660780 Primary Facility 2017-11-14 Routine/Complete Inspection No Violations Noted An RTNC inspection of the SWEPI LP Houck 433 well site in Shippen Twp., Tioga Co. was conducted on 11/14/2017 at 1350 hours. Personnel present was Mary Tassin, Shell OSR and myself. The top-hole rig was currently onsite. Miss Tassin stated they had just completed cement on the 6H well and would be onsite until possibly 11/26/2017, drilling the remaining wells.

All tanks containing fresh water and brine water were staged on secondary containment. Puddles on the pad surface near containment, were screened for field conductivity, were found to be within normal limits.

No violations are noted at this time. I departed the site at 1500 hours.

2708761 Primary Facility 2018-03-21 Routine/Complete Inspection No Violations Noted The Department of Environmental Protection conducted a routine inspection of the SWEPI LP – Houck 433 Well Pad located in Shippen Twp., Tioga Co. on 3/21/2018 @1245 hours. The weather was 38 degrees, partly cloudy with winds north @10mph. Brett McCoy, SWEPI OSR was present onsite for my inspection.

The Ensign 162 rig is currently onsite preparing to set the casing on the 6H well. The rig will begin drilling the 8H well on 3/23/2018. The rig has plans to drill 7 wells while onsite. The wells that were previously in production were shut-in and the production equipment was moved to make room for the rig. Two puddles were observed off the edge of containment with a field measured conductivity of <2 mS/cm. No pollution material was observed in the vicinity of the puddle; however tire tracks were clearly visible. The slightly elevated conductivity appears to be due to road salt. Mr. McCoy stated he would have a vac truck remove the puddles, as a precaution, immediately. No other issues were noted on the pad surfa

2724060 Primary Facility 2018-04-26 Routine/Complete Inspection No Violations Noted I met Charlie Young of SWEPI when I arrived. Ensign rig #162 on location, drilling at 4400' on the 2H well. Dry chemicals were near the edge of the sitewide containment, and I recommended to Charlie that the pallets be moved back from the berm. The cuttings backyard was very clean and well maintained. The containment berms on the pipe rack end of the rig were very flattened out from traffic driving over them; although no regulated substances were being stored on this end of the pad, I recommended to Charlie that he have the berms repaired.

For data sources see[5]

References